Your Cart is Empty
Festool 490092 Roundover Bit HW R2-OFK500
$59.00
Ships: Backordered
For use with OFKC 500 Edge Router.
This round-over router bit is designed for clean, precise edge profiling on both plastic edge banding and solid wood. It delivers smooth, consistent results for a refined edge finish on small and detailed workpieces. Its hollow, direct-thread design mounts straight onto the trim router shaft—no collet required—for stable, wobble-free cutting and excellent run-out accuracy. The result is a smooth, uniform round-over and a clean routing pattern with minimal setup and maximum control.
- Two cutting edges: Dual carbide cutting edges provide longer life and consistent cutting performance
- Round-over profile: Designed for clean, uniform edge rounding
- Precision-ground radius: Ensures smooth, accurate profiles and a consistent finished edge
- Low profile design: Allows routing in rabbets or across stacked panels
- Surface protection: The radius transitions into a 5° relief angle for smoother exits and reduced surface marking
- Ball bearing not included
- Collet-free, hollow-shaft design
- Carbide-tipped design
Specifications
- D: 27 mm (1-1/16")
- R: 2 mm (3/32")
- Cutters: 2